Configuring Ripng Route Summarization - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Define an IPv6 ACL before using it for route filtering. Refer to ACL configuration for
related information.
Define an IPv6 address prefix list before using it for route filtering. Refer to section
6.2.2 "Defining an IPv6 Prefix
2.3.1 Configuring an Additional Routing Metric
An additional routing metric can be added to the metric of an inbound or outbound RIP
route, namely, the inbound and outbound additional metric.
The outbound additional metric is added to the metric of a sent route, the route's metric
in the routing table is not changed.
The inbound additional metric is added to the metric of a received route before the route
is added into the routing table, so the route's metric is changed.
Follow these steps to configure an inbound/outbound additional routing metric:
Enter system view
Enter interface view
Specify an inbound
routing additional metric
Specify an outbound
routing additional metric

2.3.2 Configuring RIPng Route Summarization

Follow these steps to configure RIPng route summarization:
Enter system view
Enter interface view
Advertise a summary IPv6
prefix
2.3.3 Advertising a Default Route
Follow these steps to advertise a default route:
To do...
system-view
interface interface-type
interface-number
ripng metricin value
ripng metricout value
To do...
system-view
interface interface-type
interface-number
ripng summary-address
ipv6-address prefix-length
Chapter 2 IPv6 RIPng Configuration
List" for related information.
Use the command...
Use the command...
2-5
Remarks
––
––
Optional
0 by default
Optional
1 by default
Remarks
––
––
Required