H3C S7500E Series Operation Manual page 1254

Operation Manual – HA
H3C S7500E Series Ethernet Switches
[SwitchA-Vlan-interface2] vrrp ipv6 vrid 1 track interface vlan-interface 3
reduced 30
2) Configure Switch B
# Configure VLAN 2.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] vlan 2
[SwitchB-vlan2] port GigabitEthernet 2/0/5
[SwitchB-vlan2] quit
[SwitchB] interface vlan-interface 2
[SwitchB-Vlan-interface2] ipv6 address fe80::2 link-local
[SwitchB-Vlan-interface2] ipv6 address 1::2 64
# Create a standby group 1 and set its virtual IP address to FE80::10.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local
# Set the authentication mode for standby group 1 to simple and authentication key to
hello.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 authentication-mode simple hello
# Set the VRRP advertisement interval to 500 centiseconds.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 timer advertise 500
# Set Switch B to work in preemption mode. The preemption delay is five seconds.
[SwitchB-Vlan-interface2] vrrp ipv6 vrid 1 preempt-mode timer delay 5
3) Verify the configuration
After the configuration, Host B can be pinged through on Host A. You can use the
display vrrp ipv6 command to verify the configuration.
# Display detailed information of standby group 1 on Switch A.
[SwitchA-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track IF
Virtual IP
Virtual MAC
Master IP
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: SIMPLE TEXT
: Vlan-interface3
: FE80::10
: 0000-5e00-0201
: FE80::1
1-33
Chapter 1 VRRP Configuration
Adver. Timer : 500
State : Master
Run Pri : 110
Delay Time : 5
Key : hello
Pri Reduced : 30