H3C S7500E Series Operation Manual page 1163

Operation Manual – Information Center
H3C S7500E Series Ethernet Switches
Information
channel number
4
5
6
7
8
9
Note:
Configurations for the seven output destinations function independently and take effect
only after the information center is enabled.
IV. Outputting system information by source module
The system is composed of a variety of protocol modules, board drivers, and
configuration modules. The system information can be classified, filtered, and output by
source module. Some source module names and descriptions are shown in
Table 1-3 Source module list
Module name
8021X
ACL
ARP
BGP
CFM
CMD
default
DEV
DHCP
DNS
Default channel
name
logbuffer
snmpagent
channel6
channel7
channel8
channel9
802.1X module
Access Control List module
Address Resolution Protocol module
Border Gateway Protocol module
Configuration File Management module
Command line module
Default setting of all modules
Device management module
Dynamic Host Configuration Protocol module
Domain Name System module
1-3
Chapter 1 Information Center Configuration
Default output destination
Log buffer (Receives log information, a
buffer inside the router for recording
information.)
SNMP NMS (Receives trap information)
Not specified (Receives log, trap, and
debugging information)
Not specified (Receives log, trap, and
debugging information)
Not specified (Receives log, trap, and
debugging information)
Log file (Receives log, trap, and debugging
information)
Description
Table 1-3.