H3C S7500E Series Operation Manual page 1192

Operation Manual – System Maintaining and Debugging
H3C S7500E Series Ethernet Switches
Table 1-3 Default command levels
Level
0
1
2
3
Follow these steps to configure user level and command level:
Switch the user level
Enter system view
Configure the password
for switching the user
level
Configure the command
level in system view
Note:
The commands available depend on your user level when you log onto a device. For
example, if your user level is 3 and the command level of VTY 0 interface is 1, you can
use commands below level 3 (inclusive).
Privilege
Visit
ping, tracert, telnet
Monitor
refresh, reset, send
System All configuration commands except for those at manage level
Manage FTP, TFTP, Xmodem, and file system operation commands
To do...
super [ level ]
system-view
super password [ level
user-level ] { simple |
cipher } password
command-privilege
level level view view
command
Command
Use the command...
1-9
Chapter 1 Basic Configurations
Remarks
Optional
Available in user view.
—
Optional
By default, no password is
configured.
Optional