H3C S7500E Series Operation Manual page 1255

Operation Manual – HA
H3C S7500E Series Ethernet Switches
# Display detailed information of standby group 1 on Switch B.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Virtual IP
Master IP
The above information indicates that in standby group 1 Switch A is the master, Switch
B is the backup and packets sent from Host A to Host B are forwarded by Switch A.
If Switch A is in work, but its interface VLAN-interface 3 is not available, you can still
ping through Host B on Host A. You can use the display vrrp ipv6 command to view
the detailed information of the standby group.
# If Switch A is in work, but its interface VLAN-interface 3 is not available, the detailed
information of standby group 1 on Switch A is displayed.
[SwitchA-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
Admin Status
Config Pri
Preempt Mode
Auth Type
Track IF
Virtual IP
Master IP
# If Switch A is in work, but its interface VLAN-interface 3 is not available, the detailed
information of standby group 1 on Switch B is displayed.
[SwitchB-Vlan-interface2] display vrrp ipv6 verbose
IPv6 Standby Information:
Run Method
Virtual IP Ping : Enable
Interface
VRID
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 100
: YES
: SIMPLE TEXT
: FE80::10
: FE80::1
: VIRTUAL-MAC
: Vlan-interface2
: 1
: UP
: 110
: YES
: SIMPLE TEXT
: Vlan-interface3
: FE80::10
: FE80::2
: VIRTUAL-MAC
: Vlan-interface2
: 1
1-34
Chapter 1 VRRP Configuration
Adver. Timer : 500
State : Backup
Run Pri : 100
Delay Time : 5
Key : hello
Adver. Timer : 500
State : Backup
Run Pri : 80
Delay Time : 5
Key : hello
Pri Reduced : 30
Adver. Timer : 500