Configuring Vrrp For Ipv6; Vrrp For Ipv6 Configuration Task List; Enabling Users To Ping Virtual Ipv6 Addresses - H3C S7500E Series Operation Manual

Operation Manual – HA
H3C S7500E Series Ethernet Switches

1.3 Configuring VRRP for IPv6

1.3.1 VRRP for IPv6 Configuration Task List

Complete these tasks to configure VRRP for IPv6:

Enabling Users to Ping Virtual IPv6 Addresses

Configuring the Association Between Virtual IPv6 Address
and MAC Address
Creating Standby Group and Configuring Virtual IPv6
Address
Configuring Standby Group Priority, Preemption Mode and
Interface Tracking
Configuring VRRP Packet Attributes
1.3.2 Enabling Users to Ping Virtual IPv6 Addresses
You can configure whether the master switch responds to the received ICMPv6 echo
requests, that is, whether the virtual IPv6 address of a standby group can be pinged
through.
Follow these steps to enable a user to successfully ping the virtual IPv6 addresses of
standby groups:
Enter system view
Enable a user to ping
virtual IPv6 address of the
standby group
Caution:
You should configure this function before creating a standby group. Otherwise, you
cannot ping the virtual IPv6 addresses of standby groups.
Task
To do...
system-view
vrrp ipv6 ping-enable
Use the command...
1-15
Chapter 1 VRRP Configuration
Remarks
Optional
Optional
Required
Optional
Optional
Remarks
—
Optional
Enabled by default