H3C S7500E Series Operation Manual page 1262

Operation Manual – HA
H3C S7500E Series Ethernet Switches
Enable automatic
synchronization between
the AMB and SMB
Enable the manual
switchover between the
AMB and SMB
Manually configure
switchover between the
AMB and SMB
Manually restart the SMB
Caution:
SMB does not support any system configuration commands. Therefore, users
cannot execute any commands in SMB unless it has replaced the original AMB and
has become the new AMB.
After the SMB has restarted, the AMB will perform initial synchronization on the
SMB. During this process if the user presses <Enter>, the system will prompt the
user no command can be input. After the initial synchronization is completed, the
user can execute all the configuration commands in the AMB and the AMB and SMB
will keep a real-time synchronization process, meaning the configuration of the user
on the AMB will be copied to the SMB to ensure the consistency of the current
configuration of the AMB and SMB.
2.3 Displaying and Maintaining HA
Display the switchover
state
To do...
slave auto-update
config
slave switchover
{ enable | disable }
slave switchover
slave restart
To do...
display switchover state
[ slot-id ]
Use the command...
Use the command...
2-2
Chapter 2 HA Configuration
Remarks
Optional
Enabled by default.
Optional
Enabled by default
Optional
Optional
Remarks
Available in any view