H3C S7500E Series Operation Manual page 483

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
II. Network diagram
Figure 1-1 Network diagram for static routes
III. Configuration procedure
1) Configure the IPv6 addresses of all VLAN interfaces (Omitted)
2) Configure IPv6 static routes.
# Configure the default IPv6 static route on Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ipv6 route-static :: 0 4::2
# Configure two IPv6 static routes on Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Configure the default IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] ipv6 route-static :: 0 5::2
3) Configure the IPv6 addresses of hosts and gateways.
Configure the IPv6 addresses of all the hosts based upon the network diagram,
configure the default gateway of Host A as 1::1, that of Host B as 2::1, and that of Host
C as 3::1.
4) Display configuration information
# Display the IPv6 routing table of Switch A.
[SwitchA] display ipv6 routing-table
Routing Table :
Destinations : 7
Chapter 1 IPv6 Static Routing Configuration
Routes : 7
1-3