Advertising A Local Ipv6 Route; Configuring A Preferred Value For Routes From A Peer/Peer Group - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches

5.3.3 Advertising a Local IPv6 Route

Follow these steps to configure advertise a local route into the routing table:
Enter system view
Enter BGP view
Enter IPv6 address family
view
Add a local route into IPv6
BGP routing table

5.3.4 Configuring a Preferred Value for Routes from a Peer/Peer Group

Follow these steps to configure a preferred value for routes received from a peer/peer
group:
Enter system view
Enter BGP view
Enter IPv6 address family
view
Configure a preferred
value for routes received
from a peer/peer group
Note:
If you both reference a routing policy and use the command peer { ipv6-group-name |
ipv6-address } preferred-value value to set a preferred value for routes from a peer,
the routing policy sets a non-zero preferred value for routes matching it. Other routes
not matching the routing policy uses the value set with the command. If the preferred
value in the routing policy is zero, the routes matching it will also use the value set with
the command. For information about using a routing policy to set a preferred value,
refer to the peer { ipv6-group-name | ipv6-address } route-policy route-policy-name
{ import | export } command and the apply preferred-value preferred-value
command.
To do...
system-view
bgp as-number
ipv6-family
network ipv6-address
prefix-length [ short-cut |
route-policy
route-policy-name ]
To do...
system-view
bgp as-number
ipv6-family
peer { ipv6-group-name |
ipv6-address }
preferred-value value
Use the command...
Use the command...
5-4
Chapter 5 IPv6 BGP Configuration
Remarks
—
Required
—
Required
Not added by default
Remarks
—
Required
—
Optional
By default, the preferred
value is 0.