Ipv6 Is-Is Configuration Example - H3C S7500E Series Operation Manual

Operation Manual – IPv6 Routing
H3C S7500E Series Ethernet Switches
Clear the IS-IS data
information of a neighbor

4.5 IPv6 IS-IS Configuration Example

I. Network requirements
As shown in
autonomous system, and all are enabled with IPv6.
Switch A and Switch B are Level-1 switches, Switch D is a Level-2 switch, and Switch C
is a Level-1-2 switch. Switch A, Switch B, and Switch C are in area 10, while Switch D is
in area 20.
II. Network diagram
Figure 4-1 Network diagram for IPv6 IS-IS basic configuration
III. Configuration procedure
1) Configure IPv6 addresses for interfaces (omitted)
2) Configure IPv6 IS-IS
# Configure Switch A.
<SwitchA> system-view
[SwitchA] isis 1
[SwitchA-isis-1] is-level level-1
[SwitchA-isis-1] network-entity 10.0000.0000.0001.00
[SwitchA-isis-1] ipv6 enable
[SwitchA-isis-1] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] isis ipv6 enable 1
To do...
reset isis peer system-id
[ process-id ]
Figure 4-1, Switch A, Switch B, Switch C and Switch D reside in the same
Chapter 4 IPv6 IS-IS Configuration
Use the command...
4-5
Remarks
Available in user
view