Chapter
7
Fault Messages
Figure 15. Sample Twinax Hex Code Printout
Fault Messages
If a fault condition occurs in the printer, the Attention indicator on the operator
panel lights, and the first line of the operator panel message display indicates
the fault. The second line of the display indicates how to clear the fault.
Table 9: explains each fault message and describes how to correct the fault
condition. Displayed faults fall into one of two categories:
•
Operator correctable.
•
InfoPrint service representative required to correct.
Fault Correction Procedure
Before correcting a fault, read the fault explanation, then proceed to fix the
problem, taking the following steps:
1. Write down the number of the error message(s) being displayed.
2. Read the fault explanation, then proceed to fix the problem, if possible.
3. Press Stop to clear the fault message. Press Start to return to Ready
mode, and resume printing.
4. If the fault message reappears, power off the printer, wait 15 seconds,
then power on the printer.
242