InfoPrint 6500 User Manual page 255

Fault Message
146 RIBBON INK OUT
INSTALL NEW IPS RIBBON
147 H/B CONTROL MODE
SEE USERS MANUAL
148 DRIVER CIRCUIT BAD
SEE USERS MANUAL
149 HMR BANK NOT
INSTALLED
SEE USERS MANUAL
150 ERROR: EC STOPPED
AT STATE XXXX
159 HAMMERBANK HOT
160 ERROR: DC PROGRAM
NOT VAILID
161 ERROR: DRAM AT
ADDRESS XXXXXXXX
162 ERROR: EC PROGRAM
NOT VALID
163 ERROR: FLASH DID
NOT PROGRAM
Table 9: Fault Messages
Operator
Explanation
Correctable?
Yes Integrated Print
Management System
software has
determined that the
ribbon is out of ink.
No One or more hammer
coils are overheating.
No Driver circuit is faulty.
The hammer coil
count test failed.
No Hammer bank not
installed.
No XXXX is a number
from 0000 to 0010.
The Entine Controller
has stopped and is in
the state identified by
the number displayed.
No The hammerbank is
overheating.
No The printer cannot
find the data controller
program or the
validation checksum
is corrupt.
No The printer found a
defective memory
location.
Yes The printer cannot
find the engine
controller program or
the validation
checksum is corrupt.
Yes The printer
encountered an error
trying to program
flash memory.
Fault Messages
Fault Correction Procedure
Solution
Replace the ribbon and
verify ribbon life is reset to
100%.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Download the program
again. If the fault message
appears again, contact
your InfoPrint service
representative.
Download the program
again. If the fault message
appears again, contact
your InfoPrint service
representative.
255