InfoPrint 6500 User Manual page 280

Chapter 7
Fault Messages
Fault Message
E34 TRACE CMPLT
See User Manual
E99 UNKNOWN INT
See User Manual
E NET TEST UNAVAILABLE
ENERGY SAVER MODE
ACTIVE
280
Table 9: Fault Messages
Operator
Explanation
Correctable?
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes An illegal or
unsupported
instruction was
attempted in the
application program.
Yes The Ethernet PCBA is
not enabled or did not
initialize correctly.
N/A Status message:
printer is in
low–energy idle state,
all fans and higher
voltages are off, only
+5Vdc logic circuits
are active.
Solution
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
1. Cycle Power. Run the
print job again. If the
message appears,
load the latest
emulation software.
2. Cycle power. Run the
print job again. If the
message appears,
record the display
message and send it to
your next higher
support facility.
Cycle power. Wait for
"E Net Ready" to display,
then retry operation. If the
fault message appears
again, contact your
InfoPrint service
representative.
No action required. NOTE:
If the printer was in NOT
READY state when the
energy saver mode was
activated, it will remain in
the NOT READY state until
the START key is pressed.