InfoPrint 6500 User Manual page 208

Chapter 4
Emulation Configuration Menu
Left Margin
Defines where print position 1 is located. The left margin is specified as the
number of characters from the left edge of the forms. Valid values range from
the following:
•
0 Characters (the default)
•
0 – 369 Characters.
Right Margin
Defines where the last print position is located. The right margin is specified
as the number of characters from the right edge of the forms. Valid values
range from the following:
•
0 Characters (the default)
•
0 – 369 Characters
Bottom Margin
Defines the location of the last print line on the page. The bottom margin is
specified as the number of lines from the bottom of forms position. Valid
values range from the following:
•
0 Lines (the default)
•
0 – 451 Lines
Perforation Skip
•
Disable (the default). Allows printing on page perforation.
•
1/2 inch. Allows you to set up a skip-over margin of 1/2 inch. For
example, a skip-over margin of 1/2 inch allows a 1/2 inch margin at the
bottom of the page.
•
2/3 inch. Allows you to set up a skip-over margin of 2/3 inch.
•
5/6 inch. Allows you to set up a skip-over margin of 5/6 inch.
•
1 inch. Allows you to set up a skip-over margin of 1 inch.
Reset Command
Reset Command specifies the configuration that will be used by the printer
after the reset command is issued.
•
Load Factory (the default). Loads the factory default configuration for
printer use. This is the default selection.
•
Load Power On. Loads the selected power on configuration for printer
use.
208