InfoPrint 6500 User Manual page 257

Fault Message
175 ACCESS NULL
POINTER*
SEE USERS MANUAL
180 ETHERNET ADDRESS
ADAPTER NOT INSTALLED
181 ETHERNET ADAPTER
BEING INITIALIZED
182 ETHERNET DETECTED
190 SECURITY ERROR
SEE USERS MANUAL
191 SECURITY CODE
VIOLATION
192 SECURITY KEY NOT
DETECTED
194 INCOMPAT. E-NET NIC
REPLACE NIC
195 INCOMPAT. WLAN NIC
REPLACE NIC
Table 9: Fault Messages
Operator
Explanation
Correctable?
No Application software
tried to perform an
illegal printer function
or damaged logic
circuits were detected
on the controller
board.
Yes The Ethernet PCBA is
not enabled or did not
initialize correctly.
N/A Status message
indicating that the
ethernet interface is
processing the boot
procedure.
N/A Status message
indicating that the
ethernet interface has
established
communication.
No Security Key intended
for ribbon use
installed on CDB
machine.
No Security Key does not
match emulation.
No The security key is not
present or has failed.
No The Ethernet installed
in the printer is not the
correct part number
for the 6500-V printer.
No The wireless Ethernet
installed in the printer
is not the correct part
number for a 6500-V
printer.
Fault Messages
Fault Correction Procedure
Solution
Contact your InfoPrint
service representative.
Install the Ethernet
Address Adapter.
No action required.
No action required.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
257