InfoPrint 6500 User Manual page 103

Format Control
Enables the printer to reflect the same spacing as 6408/6412 Model CT0
printers after absolute and relative move commands are executed. The
following options are available:
•
Disable (the default) does not reflect distance, generated by the Code V
feature, IGP feature, and Hex Transparent control code sequence, in the
new position (after absolute and relative move commands are executed).
•
Enable. Reflects 6408/6412 Model CT0 distance, generated by the Code
V feature, IGP feature, and Hex Transparent control code sequence, in
the new position (after absolute and relative move commands are
executed).
Maximum Printable Width
Sets the maximum width of the printer when using a CT host interface.
•
13.2 Inches (the default)
•
13.6 Inches
NOTE: The 5250 interface menu and 3270 interface menu option for
maximum printable width use the same internal variable. Setting this
option in either menu will make it the current setting for the printer,
independent of the interface used.
Although the LP+ emulation maintains width in characters, the
maximum printable width in characters is controlled by the same
internal variable that is set by the 5250 interface menu and 3270
interface menu option for maximum printable width option.
C/T Hotport
Gives the printer the ability to handle multiple data streams simultaneously. It
allows the printer to serve hosts attached to the serial, parallel, and either
coax or twinax ports as if they were the only interface connected.
Port Type
Selects the type of port to be used. The Disable selection disables the port
from the hotport process. The available selections are:
•
Twinax (the default)
•
Coax
•
Disable
NOTE: Changing the Port Type in this menu option also changes the Port
Type setting in the Coax Interface Menu.
5250 Interface Menu
Compatibility Options Menu
103