InfoPrint 6500 User Manual page 88

Chapter 4
Coax Interface Menu
PA2
PA2 is only valid when the printer is in the NOT READY state and the coax
SCS data stream is active. This function displays the "PA2 ENABLED"
message when the Enter key is pressed and sends a special operator
request to the host when the printer is made READY.
•
Disable (the default)
•
Enable
NOTE: Selecting the PA2 menu item again ("PA2 DISABLED" appears on
Buffer Reprint
This option is only valid when the printer is in the NOT READY state and the
Coax SCS data stream is active. The printer displays the "ENABLED"
message when the Enter key is pressed, and sends an Intervention Required
Status to the host when the printer goes to READY state.
•
Disable (the default)
•
Enable
NOTE: Selecting the Buffer Reprint menu item again ("DISABLED" appears
Early Print Complete
Early Print Complete capability allows the printer to send Print Complete
status to the host before the printer is actually done printing all data.
•
Disable (the default). The printer will suppress the Early Print Complete
response until all printing is complete.
•
Enable. The printer will send an acknowledgement to the host when it is
able to accept more data.
NOTE: When an Early Print Complete is enabled and an error occurs, the
88
the operator panel) or selecting the PA1 menu item will reset the
pending PA2 function.
on the operator panel) will reset the Buffer Reprint function.
data in the printer will remain in the buffer (regardless of the setting of
the Cancel Buffer option). It is recommended that local procedures be
followed to recover from the error.
Do not select Early Print Complete while a print job is in progress. If
this is done you will need to restart the printer.