InfoPrint 6500 User Manual page 107

Print Language
PRINT LANGUAGE specifies the set of print languages used by the printer.
Refer to the previous page for print language menus.
Specifying a print quality of OCR A or OCR B will change the print language to
OCR A or OCR B.
When OCR A or OCR B is selected as the default print language, OCR A and
OCR B are the only available values for this print quality. If a different print
quality value is desired, the print language must be changed first.
Print Character Table
PRINT CHARACTER TABLE prints out a table of the 3270 interface current
character set.
Character sets are shown in the InfoPrint 6500 Line Matrix Printers: CTA
Programmer's Reference Manual.
Active Print Language
Selects which group of print language sets (Standard or Alternate) will be
active.
•
Standard Print Language (the default)
•
Alternate Print Language
Early Print Complete
Allows the printer to indicate to the host that print has completed before it
actually occurs. This can improve throughput in certain modes.
•
Disable (the default). The printer will not respond until printing is
complete.
•
Enable. The printer will indicate to the host that it is able to accept more
data before printing is complete.
NOTE: Early Print Complete should only be enabled to improve performance
when running DSC (LU0) or DSE (LU3). This does not apply in SNA
(LU1) mode. Interventions such as form jams and end of forms will
not be sent to the host when Early Print Complete is enabled.
Hex Transparent Control
You can enable additional features that are not available in standard InfoPrint
emulations. To access these features, send lead-in character text commands
in the data stream. You can also use ASCII codes 80 hex through 9F hex as
control codes if configured to do so.
3270 Interface Menu
Compatibility Options Menu
107