InfoPrint 6500 User Manual page 287

Fault Message
TCP PORT BUSY
TESTING HARDWARE
PLEASE WAIT
TIP MISMATCH
USE CORRECT RBN
TOP OF FORM SET
TRANSPORT CALIBRATION
COMPLETE
WAITING FOR
ETHERNET ADAPTER
WELD NOT DETECT
SEE USERS MANUAL
WELD RESET ERROR
SEE USERS MANUAL
Table 9: Fault Messages
Operator
Explanation
Correctable?
No Error message
reported by the
Printer Manager when
the ethernet card is
installed. The network
address given in the
printer properties was
reached, but the
printer port is "busy."
When the port setting
is "Serial" the printer
manager software
cannot interact with
the ethernet card,
although the card will
respond to other TCP/
IP utilities.
N/A Status message when
printer runs self–tests
and initialization
routines.
Yes The incorrect
cartridge type is being
used for the printer.
N/A Non–error status
message.
N/A Status message:
displays when
Transport calibration
is complete.
N/A Status message:
appears when the
printer is first powered
on if the Ethernet port
is enabled or Ethernet
PCI card is installed.
No The cartridge weld
was not detected.
No The cartridge weld
circuitry lost power.
Fault Correction Procedure
Solution
Refer to the
6500 Maintenance
Information Manual.
No action required.
Install the correct ribbon
cartridge type in the printer.
No action required.
No action required.
No action required.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
287