InfoPrint 6500 User Manual page 83

Maximum Printable Width
MAXIMUM PRINTABLE WIDTH sets the maximum width of the printer when
using a CT host interface.
•
13.2 Inches (the default)
•
13.6 Inches
NOTE: The twinax interface menu and coax interface menu option for
maximum printable width use the same internal variable. Setting this
option in either menu will make it the current setting for the printer,
independent of the interface used.
Although the LP+ emulation maintains width in characters, the
maximum printable width in characters is controlled by the same
internal variable that is set by the twinax interface menu and coax
interface menu option for maximum printable width option.
Hex Print Mode
When enabled, the HEX PRINT MODE parameter prints the EBCDIC data
and control codes received from the host as hex values.
•
Disable (the default)
•
Enable
Refer to page 241 to obtain a hex code printout.
NOTE: Printing in Hex Mode may alter print attributes set by the host
computer. A power cycle may be required after changing HEX PRINT
MODE from enable to disable.
C/T Hotport
Gives the printer the ability to handle multiple data streams simultaneously. It
allows the printer to serve hosts attached to the serial, parallel, and either
coax or twinax ports as if they were the only interface connected.
Port Type
Selects the type of port to be used. The Disable selection disables the port
from the hotport process. The available selections are:
•
Twinax (the default)
•
Coax
•
Disable
NOTE: Changing the Port Type in this menu option also changes the Port
Type setting in the Coax Interface Menu.
Twinax Interface Menu
83