InfoPrint 6500 User Manual page 159

Postnet Barcode Width
Determines the width of Postnet bar code. This option applies to non-rotated
Postnet bar codes.
•
Standard (the default). Postnet bar codes are printed at the standard
width.
•
Narrow. Postnet bar codes are printed with a narrow width.
NOTE: The printer caches bar codes to improve performance. Therefore, to
change this configuration value, you will need to select the desired
setting, save the value in a custom set, then power the printer off and
then power the printer back on.
UPC/EAN Barcode HRI
Determines whether bar code HRI (human readable information) prints with
UPC and EAN bar codes.
•
On (the default). The printer always prints HRI with UPC and EAN bar
codes, regardless of the HRI flag contained in the IPDS bar code
application command.
•
Data Stream Setting. The printer uses the HRI flag in the IPDS bar code
application command to determine whether or not to print HRI with UPC
and EAN bar codes. See the InfoPrint 6500 Line Matrix Printers: IPDS
Programmer's Reference Manual for more information about IPDS bar
code application commands.
Enhanced Bar Code Mode
The Enhanced Bar Code Mode option interweaves the dots in IPDS bar
codes so that more bar codes can be printed before the ribbon must be
replaced.
•
Disable (the default). Bar codes are printed in one of the standard
qualities, as determined by the Bar Code Quality option and IPDS
application commands.
•
Enable. Bar codes are printed in the enhanced mode.
Only certain bar code types, sizes, an orientations are supported in Enhanced
Bar Code Mode.
•
Only bar codes with a unit module width of 0.017 inches are supported in
Enhanced Bar Code Mode.
•
For non-rotated bar codes, all bar code types except Postnet and Royal
Mail are supported in Enhanced Bar Code Mode. Enhanced bar codes
printed in these orientations will print at approximately the same speed as
standard high quality bar codes.
IPDS Emulation Menu
159