InfoPrint 6500 User Manual page 284

Chapter 7
Fault Messages
Fault Message
OPERATOR MENU
UNLOCKED
P00 ERROR:SYSTEM FAULT
P05 DIAGNOSTIC TEST
PASSED
P17 SECURITY VIOLATION
PA1 SELECTED
PA2 SELECTED
PAP FD DRVR CIR*
SEE USERS MANUAL
PRINTER UNDER REMOTE
CONTROL
QUEUE OVERRUN
READY
284
Table 9: Fault Messages
Operator
Explanation
Correctable?
N/A Non–error status
message.
Yes Firmware error on the
controller board.
N/A Non–error status
message.
No Security code of PAL
on controller board
does not match code
of firmware on the
controller board.
N/A Attach status
message.
N/A Attach status
message.
No Paper Feed Driver
Circuit. The paper
feed driver circuit on
the controller board is
drawing too much
current.
Yes Indicates that remote
management software
has control of the
printer.
No In CT twinax
emualtion, the print
buffer has overflowed.
N/A Printer state
message: printer is
online and in
communication with
host.
Solution
No action required.
Cycle power. Run the print
job again. If the message
appears, download the
emulation software again.
If the message appears
again, contact your
InfoPrint service
representative.
No action required.
Contact your InfoPrint
service representative.
No action required.
No action required.
Contact your InfoPrint
service representative.
No action required.
Contact your InfoPrint
service representative.
No action required.