InfoPrint 6500 User Manual page 258

Chapter 7
Fault Messages
Fault Message
200 SOFTWARE ERROR*
RECYCLE POWER
301 RIBBON INK LOW
INSTALL NEW IPS RIBBON
302 EXCESSIVE RIBBON
WEAR
INSTALL NEW IPS RIBBON
303 BARCODE NOT
DETECTED
INSTALL NEW IPS RIBBON
NOTE: For spool ribbon
printers only.
304 BARCODE DAMAGED
REVERSE RIBBON SPOOLS
NOTE: For spool ribbon
printers only.
305 OLD RIBBON
DETECTED
INSTALL NEW IPS RIBBON
306 UNKNOWN RIBBON
INSTALL NEW IPS RIBBON
307 UNKNOWN RIBBON
INSTALL NEW IPS RIBBON
258
Table 9: Fault Messages
Operator
Explanation
Correctable?
No Application software
tried to perform an
illegal printer function
or damaged logic
circuits were detected
on the controller
board.
Yes Message is displayed
when RibbonMinder
feature is enabled and
ribbon ink reaches 2%
level.
Yes Displayed when
ribbon reaches end of
life, whether
RibbonMinder is
enabled or not.
Yes No barcode seen on
the ribbon spool.
Indicates missing
label or damaged
sensor.
Yes Barcode detected, but
not complete.
Yes The sensor detects a
ribbon that was
previously declared to
be at the end of it its
service life.
Yes Ribbon was not an
InfoPrint coded
barcode.
Yes Ribbon not
authorized.
Solution
Contact your InfoPrint
service representative.
Install a new InfoPrint
ribbon.
Install a new InfoPrint
ribbon.
Install a new InfoPrint
ribbon.
Reverse the ribbon spools.
Install a new InfoPrint
ribbon.
Install a new InfoPrint
ribbon.
Install a new InfoPrint
ribbon.