InfoPrint 6500 User Manual page 251

Fault Message
092 RBN DRVR CIRCUIT
SEE USERS MANUAL
101 UPPER DRIVER
SHORT*
SEE USERS MANUAL
102 LOWER DRIVER
SHORT*
SEE USERS MANUAL
104 ERROR:DP FIFO BUSY
105 HAMMER <#> CHECK
110 STACK OVERFLOW*
SEE USERS MANUAL
111 STACK UNDERFLOW*
112 UNDEFINED OPCODE*
SEE USERS MANUAL
113 INSTRUCTION SET
SEE USERS MANUAL
114 ILLGL OPR ACCESS
SEE USERS MANUAL
Table 9: Fault Messages
Operator
Explanation
Correctable?
No The ribbon driver
circuit on the
controller board is
drawing too much
current.
No Upper driver short.
Hammer driver
circuits on the
controller board
shorted to ground.
No Circuit(s) on the
hammer bank or in
the hammer bank
power cable shorted
to ground.
No There is a timing
problem in the Engine
Controller (EC)
firmware.
No Hammer coil is open.
No Fatal firmware error
on the controller
board.
No Fatal firmware error
on the controller
board.
No Undefined Opcode.
Fatal firmware error
on the controller
board.
No Protected instruction.
Fatal firmware error
on the controller
board.
No Illegal Operand
Accessed. Fatal
firmware error on the
controller board.
Fault Messages
Fault Correction Procedure
Solution
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Cycle power. If problem
does not clear, contact
your InfoPrint service
representative.
(You can continue to print
with degraded print
quality.) Contact your
InfoPrint service
representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
Contact your InfoPrint
service representative.
251