Pc Parallel Menu - InfoPrint 6500 User Manual

Chapter 4
Parallel Interface Menu

PC Parallel Menu

The PC PARALLEL menu configures the electrical signals to operate as a
PC Parallel printer.
PC Parallel
(from page 136)
Data Bit 8
Enable* Standard*
Disable Inverted
Latch
Data On
Leading Edge* Disable*
Trailing Edge Enable
Trickle
Time
1/4 sec*
1/2 sec
1 sec
2 sec
4 sec
8 sec
16 sec
OFF
Data Bit 8
The DATA BIT 8 parameter allows access to the extended ASCII character
set. When this parameter is disabled, the printer interprets bit 8 of each
incoming data character as a zero, regardless of its actual setting.
The extended ASCII character set is shown in the InfoPrint 6500 Line Matrix
Printers: ASCII Programmer's Reference Manual.
•
Enable (the default)
•
Disable.
138
Data Strobe
Polarity Polarity
Standard*
Inverted
Prime TOF Act at
Signal Prime Signal
Form Feed at Reset*
No Form Feed at Reset
To cycle through the menus and its
options, press MENU then:
To enter a menu or select menu options,
press ENTER.
To return to a previous menu level,
press RETURN.
To exit the configuration menus
and return to READY, press START.
* = Factory Default
Response Busy On
Polarity Strobe
Standard* Enable*
Inverted Disable
Buffer Size in
Kbytes Trickle
16* Disable*
1 - 16 Enable
↑
Scroll/
OR
Micro
Auto
↓
Scroll/
Micro