Configuring A Cluster Member; Table 410 Set Group Add Mac Command; Table 411 Set Group Add Mac Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
Result
Purpose
Steps
250 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
member switch cannot change itself to a candidate switch
or command switch.
In setting command switch, VLAN to which the layer 3
port is bound shall be the specified VLAN for collecting
topology information.
a command switch,
topology information cannot be changed.
Command switch is allowed to be a candidate switch or
independent switch only when the cluster has no member
switch.
E
ND OF STEPS
Cluster management Unique ID of cluster has been configured.

Configuring a Cluster Member

This topic describes the configuration of cluster member to
add/delete.
For the configuration of cluster member, perform the following
steps.
1. To add a member based on device MAC address,
command set group add mac <xx.
config mode.
T 4 1 0 S G
A B L E E T
Format
set group add
mac <xx. xx.
xx>
Result: This adds a membe based on device MAC address.
2. To add a member based on device MAC address and
specify member ID, use command set group add mac <xx.
xx. xx> <1-255> in group config mode.
Table 411.
T 4 1 1 S G
A B L E E T
Format
set group add
mac <xx. xx.
xx> <1-255>
Result: This adds a member based on device MAC address
and specify member ID.
Once a switch is configured to be
specified VLAN for collecting
This is shown in Table 410.
A M C
R O U P D D A C O M M A N D
Mode
group config
A M C
R O U P D D A C O M M A N D
Mode
group config
use
xx. xx> in group
Function
This adds a
member based on
device MAC address
This is shown in
Function
This adds a
member based on
device MAC address
and specify member
ID