Table 269 Dot1X Server Timeout Command; Table 270 Dot1X Max Request Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
168 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
T 2 6 9 D 1
A B L E O T X
Format
dot1x server-
timeout <1-
65535>
Result: This set timeout time for authentication system to
receive data packets from authentication server.
5. To set maximum times of request resending when timer
expires before authentication system receives Challenge
response from client,
<1-10> in nas config mode.
T 2 7 0 D 1
A B L E O T X
Format
dot1x max-
request <1-10>
Result: This set maximum time of request resending when
timer expires
Challenge response from client.
Note: 802.
EAPOL data
authentication system and RADIUS data packets between
authentication system and authentication server.
exchange of data packets,
used for control purpose:
QuietPeriod
authentication system will not receive authentication
request from client system after first authentication
failure.
continuous authentication attempts.
TxPeriod refers to the time after which authentication
system will resend EAPOL data packets to client system
when it does not receive the response from client system.
Supplicant Timeout and serverTimeout respectively refer
to the time during which authentication system shall
receive data packet from client system and authentication
server.
S T C
E R V E R I M E O U T O M M A N D
Mode
nas config
use command dot1x max-request
This is shown in Table 270.
M R C
A X E Q U E S T O M M A N D
Mode
nas config
before authentication
1x realizes the access control by exchanging
packets between
the following parameters are
refers to the
This function can prevent the subscriber's
Function
This set timeout
time for
authentication
system to receive
data packets from
authentication
server
Function
This set maximum
times of request
resending when
timer expires before
authentication
system receives
Challenge response
from client
system receives
client system
During
period before which
and