Configuring Radius; Table 271 Show Aaa Control Port Command; Table 272 Show Dot1X Command; Table 273 Radius Isp Command - Zte ZXR10 2920 User Manual

Max-request
resending when timer expires before authentication
system receives Challenge response from client system.
6. To display the 802.
command show aaa-control port [<portlist>] in nas config
mode.
T
A B L E
Format
show aaa-control
port [<portlist>]
Result: This displays the 802.
7.
command show dot1x in nas config mode.
in Table 272.
T
A B L E
Format
show dot1x
Result: This displays the 802.
E
ND OF STEPS
Result Protocol parameters or 802.
2920/2928/2952.

Configuring RADIUS

Purpose This topic describes the RADIUS configuration of ZXR10
2920/2928/2952.
Steps For the configuration of RADIUS, perform the following steps.
1. To add/delete an ISP domain, use command radius isp
<ispname> {enable|disable} in nas config mode.
shown in Table 273.
T
A B L E
Format
radius isp
<ispname>
{enable|disable}
Result: This add/delete an ISP domain.
refers
This is shown in Table 271.
2 7 1 S A A A C
H O W O N T R O L
Mode
nas config
To display the 802.
2 7 2 S D 1 C
H O W O T X O M M A N D
Mode
nas config
2 7 3 R I C
A D I U S S P O M M A N D
Mode
nas config
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 8 Access Service
to maximum times
1x configuration of the port, use
P C
O R T O M M A N D
Function
This displays the
802.
configuration of the
port
1x configuration of the port.
1x protocol parameters, use
Function
This displays the
802.
parameters
1x protocol parameters.
1x has been configured on ZXR10
Function
This add/delete an
ISP domain
of request
1x
This is shown
1x protocol
This is
169