Table 177 Set Stp Relay Command; Table 178 Set Stp Revision Command; Table 179 Set Stp Trunk Command; Table 180 Set Stp Trunk Linktype Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
120 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
T 1 7 7 S S
A B L E E T
Format
set stp relay
{enable|disable}
Result: This enables/disables STP relay.
32. To set the MST version, use command set stp revision
<0-65535> in global configuration mode.
Table 178.
T 1 7 8 S S
A B L E E T
Format
set stp revision <0-
65535>
Result: This sets the MST version.
33. To enable/disable STP trunk,
trunk <trunklist> {enable|disable} in global configuration
mode. This is shown in Table 179.
T 1 7 9 S S
A B L E E T
Format
set stp trunk
<trunklist>
{enable|disable}
Result: This enable/disable STP trunk.
34. To set trunk's link type of the instance,
set stp trunk <trunklist> linktype {point-point|shared}
in global configuration mode.
T 1 8 0 S S
A B L E E T
Format
set stp trunk
<trunklist> linktype
{point-
point|shared}
Result: This sets trunk link type of the instance.
35. To set trunk packet type of instance, use command set
stp trunk
{IEEE|CISCO|HUAWEI|
configuration mode.
R C
T P E L A Y O M M A N D
Mode
Global
config
R C
T P E V I S I O N O M M A N D
Mode
Global
config
T C
T P R U N K O M M A N D
Mode
Global
config
This is shown in Table 180.
T L C
T P R U N K I N K T Y P E O M M A N D
Mode
Global
config
< trunkid
HAMMER|extend}}
This is shown in Table 181.
Function
This enables/disables STP
relay
This is shown in
Function
This sets the MST version
use command set stp
Function
This enable/disable stp
trunk
use command
Function
This sets trunk link type of
the instance
> packettype
in global