Zte ZXR10 2920 User Manual page 60

ZXR10 2920/2928/2952
Steps
46 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
For the configuration of online command help,
following steps.
1. Input ? behind the prompt of any command mode to view all
commands and brief descriptions of this mode.
Result: Command mode is viewed.
Example: An example given below shows ? behind the
prompt of the command mode.
zte>?
enable
exit
help
help system
show
list
zte>
2. Input the question mark behind a character or character
string.
Result: This will view the list of commands or keywords
beginning with that character or character string.
Example: An example given below shows the character
string.
zte(cfg)#c?
config clear
zte(cfg)#c
3. Input ? behind the command, keyword and parameter.
Result: It shows the keyword or parameter to be input next
and its brief explanation.
Example: An example is given below.
zte(cfg)#config ?
snmp enter SNMP config mode
router enter router config mode
tffs enter file system config mode
nas enter nas config mode
group enter group management config mode
acl enter acl config mode
zte(cfg)#config
4. If a wrong command, keyword or parameter is entered then
press Enter.
Result: It will show message "Command not found" will be
displayed on the interface.
Example: An example is given below:
enable configure mode
exit from user mode
description of the interactive
show config information
print command list
create
perform the