Table 390 Set Alarm Command - Zte ZXR10 2920 User Manual

<1-65535> {rising|falling}|owner
{valid|underCreation|createRequest|
SNMP config mode.
T 3 9 0 S A
A B L E E T L A R M
Format
set alarm <1-65535> {interval <1-
65535>|variable <mib-
oid>|sampletype
{absolute|delta}|startup
{rising|falling|both}|threshold <1-
65535> eventindex <1-65535>
{rising|falling}|owner
<string>|status
{valid|underCreation|createRequest|
invalid}}
Result: These create/configure instances of the alarm group.
Command line configuration of alarm group is to configure
alarmTable in the alarm group.
alarmInterval.
alarmVariable: It indicates the object identifier of a
specific variable to be sampled in the local mib,
example, for sampling the etherHistoryBroadcastPkts,
the variable value shall be 1.
2. 1. 7. x.
bucket of an instance of the history group.
alarmSampleType: The "absolute" indicates the absolute
value, and "delta" indicates the relative value.
alarmStartupAlarm:
"fallingAlarm(2)" and "risingOrFallingAlarm(3)",
indicate that, after the instance becomes effective, the
first sampling starts when the rising sampling value
exceeds the threshold, the falling sampling value is lower
than the threshold or both cases occur simultaneously.
alarmRisingThreshold.
alarmFallingThreshold.
alarmRisingEventIndex.
alarmFallingEventIndex.
alarmOwner.
alarmStatus: It
"createRequest" and "invalid".
"invalid", the alarm instance is deleted.
Alarm variable can be configured only when object to be
sampled specified by alarm variable can sample data.
Status can be set to "valid" only when alarm variable is
configured successfully.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 Network Management
This is shown in Table 390.
C
O M M A N D
The configuration involves:
3. 6.
x, where, "x. x" indicates the sampling
It can be
can be "valid",
<string>|status
invalid}} in
Mode Function
SNMP These
config create/configure
instances of the
alarm group
for
1. 2. 1. 16. 2.
"risingAlarm(1)",
which
"underCreation",
When it is set to
237