Configuring Cluster Parameters; Table 412 Set Group Add Device Command; Table 413 Set Group Delete Member Command; Table 414 Set Group Name Command - Zte ZXR10 2920 User Manual

3. To add a member based on temporary device ID obtained
from collected topology information,
group add device <idlist> in group config mode.
shown in Table 412.
T
A B L E
Format
set group add
device <idlist>
Result: This adds a member based on temporary device ID
obtained from collected topology information.
4. To delete a device with specified member ID from cluster,
use command set group delete member <idlist> in group
config mode.
T
A B L E
Format
set group delete
member <idlist>
Result: This deletes a device with specified member ID from
cluster.
E
ND OF STEPS
Result Cluster member has been add/delet.
Note: When a device is added to cluster but member ID is not
specified,
member.

Configuring Cluster Parameters

Purpose This topic describes the configuration of cluster parameters.
Steps For the configuration of cluster parameters,
following steps.
1. To set cluster name,
<name> in group config mode.
T
A B L E
Format
set group name
4 1 2 S G A D
E T R O U P D D
Mode
group config
This is shown in Table 413.
4 1 3 S G D
E T R O U P E L E T E
Mode
group config
system automatically allocates a unique ID to the
4 1 4 S G N
E T R O U P A M E
Mode
group config
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 Network Management
use command set
C
E V I C E O M M A N D
Function
This adds a
member based on
temporary device
ID obtained from
collected topology
information
M C
E M B E R O M M A N D
Function
This deleted a
device with
specified member
ID from cluster
use command set group name
This is shown in Table 414.
C
O M M A N D
Function
This sets cluster
This is
perform the
251