Configuring Rmon; Table 386 Set Rmon Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
History
Statistics
Event
Alarm
Purpose
Steps
234 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
console and remote monitor.
availability method to monitor behaviors of subnets in case of
reducing oad of other agents and management stations.
RMON specifications refers to the definition of RMON MIB.
ZXR10 2920/2928/2952 supports four groups of RMON MIB.
History records periodic statistics sample of information that can
be obtained from statistics group.
Statistics maintains basic application and error statistics of each
subnet that the agent monitors.
Event is a table related to all events generated by RMON agents.
Alarm allows operators of management console to set sampling
interval and alarm threshold for any count or integer recorded
by RMON agents.
All these groups store data collected by monitor and derived
data and statistics.
event group. These data can be obtained through MIB browser.
RMON control information can be configured through MIB
browser, and a HyperTerminal or remote Telnet command line.
RMON sampling information and statistics are obtained through
MIB browser.

Configuring RMON

This topic describes the configuration of RMON through a
HyperTerminal or remote Telnet.
For the configuration of RMON, perform the following steps.
1. To enable/disable RMON function,
rmon {enable|disable} in SNMP config mode.
shown in Table 386.
T 3 8 6 S R
A B L E E T
Format
set rmon
{enable|disable}
Result: This enable/disable RMON function.
Note: By default, RMON function is disabled.
etherStatsTable
statistics groups in history group can be implemented only
when RMON function is enabled.
data sampling stops if the RMON function is disabled.
2. To create/configure instances of history group,
command
{datasource<portname>|bucketRequested
65535>|owner
RMON offers an efficient and high
Alarm group is based on implementation of
C
M O N O M M A N D
Mode
SNMP config
information in
set history
<string>|interval
use command set
This is
Function
This enable/disable
RMON function
Sampling of
etherHistoryTable
During the sampling,
<1-65535>
<1-3600>| status
and
use
<1-