Configuring Syslog; Table 306 Set Syslog Command; Table 307 Set Syslog Level Command; Table 308 Set Syslog Server Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
Purpose
Steps
186 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）

Configuring Syslog

This topic describes the configuration of Syslog on ZXR10
2920/2928/2952.
For the configuration of Syslog, perform the following steps.
1. To enable/disable syslog,
global configuration mode.
T 3 0 6 S S
A B L E E T
Format
set syslog
Result: This enable/disable syslog.
Note: By default syslog is disabled.
when there
performance will degrade.
2. To define syslog information level,
syslog level in global configuration mode.
Table 307.
T 3 0 7 S S
A B L E E T
Format
set syslog level
Result: This defines syslog information level.
Note: Default level of syslog information is informational.
If level of syslog information is configured to emergencies,
the information will be sent firstly.
3. To setup syslog information receiving server,
command set syslog {add | delete} server in global
configuration mode.
server can be configured.
T 3 0 8 S S
A B L E E T
Format
set syslog {add |
delete} server
Result: This setups syslog information receiving server.
4. To enable/disable module of syslog,
syslog module in global configuration mode.
shown in Table 309.
use command set syslog in
This is shown in Table 306.
C
Y S L O G O M M A N D
Mode
global config
is much log information,
L C
Y S L O G E V E L O M M A N D
Mode
global config
At most five IP addresses of syslog
This is shown in Table 308.
S C
Y S L O G E R V E R O M M A N D
Mode
global config
Function
This enable/disable
syslog
Syslog is enabled
the system
use command set
This is shown in
Function
This defines syslog
information level
use
Function
This setups syslog
information
receiving server
use command set
This is