Table 210 Set Qos Policer Parameters Command; Table 211 Set Qos Policer Parameters Command; Table 212 Set Qos Policer Parameters Command - Zte ZXR10 2920 User Manual

T 2 1 0 S Q
A B L E E T O S
Format
set bandwidth
feport <portlist>
ingress session
<0-3> mgmt-no-
ratelimit {enable
| disable}
Result: This configures the ingress session mgmt-no-
ratelimit of flux monitor.
12. To configure the ingress session of the flux monitor, use
command set
session <0-3> {enable | disable}in global configuration
mode. This is shown in Table 203.
T 2 1 1 S Q
A B L E E T O S
Format
set bandwidth
feport <portlist>
ingress session
<0-3> {enable |
disable}
Result: This configures the ingress session of flux monitor.
13. To configure the egress session of the flux monitor, use
command set bandwidth feport <portlist> egress {{on
rate <64-1000000>} | off}in global configuration mode.
This is shown in Table 203.
T 2 1 2 S Q
A B L E E T O S
Format
set bandwidth
feport <portlist>
egress {{on rate
<64-1000000>} |
off}
Result: This configures the egress session of flux monitor.
14. To configure the geport ingress session of the flux
monitor, use command set bandwidth geport <portlist>
ingress {{on rate <2000-1000000> } | off }in global
configuration mode.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
P P
O L I C E R A R A M E T E R S
Mode
global config
bandwidth feport
P P
O L I C E R A R A M E T E R S
Mode
global config
P P
O L I C E R A R A M E T E R S
Mode
global config
This is shown in Table 203.
C
O M M A N D
Function
This configures the
ingress session
mgmt-no-ratelimit
<portlist> ingress
C
O M M A N D
Function
This configures the
ingress session
mgmt-no-ratelimit
C
O M M A N D
Function
This configures the
egress session
137