Quality Of Service (Qos); Table 199 Port Commands - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
Result
Data Packet
Priority
132 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
1. To configure ACL to a physical port,
command in global configuration mode as shown in Table
199.
T 1 9 9 P
A B L E O R T
Format
set port <portlist>
acl <acl-number>
{enable |
disable}
set trunk
<trunktlist> acl
<acl-number>
{enable |
disable}
set vlan <valnlist>
acl <acl-number>
{enable |
disable}
Result: This enables/disables port, trunk and Vlan.
Note: A physical port can only have one ACL.
necessary to release the current bound when you want to
bind a new one in the case that an old one has applied to the
physical port, otherwise, a false message will return.
E
ND OF STEPS
ACL has been configured to a physical port.

Quality of Service (QoS)

ZXR10 2920/2928/2952 provides QoS function and priority
control function.
determined by source MAC address priority of the data packets,
VLAN priority, 802.
the default port priority.
determined in the following sequence:
Priority of the data packets sent by CPU (determined by CPU).
Priority of MGMT data packets (management data packets
such as the BPDU packets).
packets is determined by the initialization.
Priority of static source MAC address.
VLAN priority.
802. 1P user priority.
Layer 3 DSCP priority.
Default port priority.
C
O M M A N D S
Mode
global config
global config
global config
Priority of the data packets can be
1P user priority, layer 3 DSCP priority, or
The priority of a data packet is
Priority of the management
use the following
Function
This
enables/disables
port ACL
This
enables/disables
trunk ACL
This
enables/disables
Vlan ACL
It is