Sflow Monitoring Overview; Configuring Sflow; Table 346 Set Sflow Agent Address Command - Zte ZXR10 2920 User Manual

Show Configuration of Switch B

sFlow Monitoring Overview

Description of Sample Flow (sFlow) is a technique to monitor data transmission
sFlow of network equipments such as routers and switches.
monitors flow of 10-gigabit or even bigger speed,
advantages of timely,
sflow is an expert format,
monitored data packets.
network equipments to send the sampled data packets to the
sFlow collectors.
packets then gets information of current network.

Configuring sFlow

Purpose This topic describes the configuration of sFlow on ZXR10
2920/2928/2952/5116-FI/5124-FI.
Steps For the configuration of sFlow, perform the following steps.
1.
2.
zte(cfg)#show vbas
vbas enable
trust port :1
cascade port :
sFlow collectors analyzes and processes the
To set proxy IP address of sFlow,
sflow agent-address <A.
configuration mode.
T 3 4 6 S F
A B L E E T S L O W
Format
set sflow agent-
address <A. B.
C. D>
Result: This sets proxy IP address of sFlow.
Note: Proxy IP address should be layer 3 poet IP address of
switches. If there are no enabled layer 3 ports on the
switches, proxy IP address of sFlow can not be set.
To set IP address of sFlow collector, use command set
sflow collector-address <A.
configuration mode.
Confidential and Proprietary Information of ZTE CORPORATION
actual, low-cost and being upgraded.
and adds more information of
It uses sFlow proxy embedded in
B.
This is shown in Table 346.
A A C
G E N T D D R E S S O M M A N D
Mode
global config
B.
This is shown in Table 347.
Chapter 8 Access Service
sFlow
and has
use command set
C. D> in global
Function
This sets proxy IP
address of sFlow
C. D> in global
207