Zte ZXR10 2920 User Manual page 104

ZXR10 2920/2928/2952
Result
Note
Example
90 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
T A B L E 9 9 S
H O W
Format
show lacp port
[<portlist >] in
Result: This displays the information of the port where the
LACP is involved in the aggregation.
E
ND OF STEPS
Link aggregation is configured.
After the configuration of the aggregation group,
settings can be performed on it,
adding it to the VLAN, setting the static binding MAC address,
and so on.
This example describes that switch A and switch B are connected
through aggregation port (binding the port 15 and port 16).
Port 1 of switch A and port 2 of switch B belong to VLAN2. Port
3 of switch A and port 4 of switch B belong to VLAN2.
Members of same VLAN can communicate with each other.
This is shown in Figure 25.
F 2 5 L C
I G U R E A C P O N F I G U R A T I O N
Switch A
p1
Configuration of switch A
zte(cfg)#set lacp enable
zte(cfg)#set lacp aggregator 3 add port 15-16
zte(cfg)#set lacp aggregator 3 mode dynamic
zte(cfg)#set vlan 2 add trunk 3 tag
zte(cfg)#set vlan 2 add port 1 untag
zte(cfg)#set vlan 3 add trunk 3 tag
zte(cfg)#set vlan 3 add port 3 untag
zte(cfg)#set port 1 pvid 2
zte(cfg)#set port 3 pvid 3
zte(cfg)#set vlan 2-3 enable
L P C
A C P O R T O M M A N D
Mode Function
This displays the information of the
Global
port where the LACP is involved in
config
the aggregation
such as setting the PVID,
p15 p15
p16 p16
p3
various
Switch B
p2
p4