Table 393 Set Zdp Port Command; Table 394 Set Zdp Trunk Command; Table 395 Set Zdp Holdtime Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
244 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
2. To enable/disable port ZDP function, use command set
zdp port <portlist> {enable|disable} in group config
mode. This is shown in Table 393.
T 3 9 3 S Z
A B L E E T
Format
set zdp port
<portlist>
{enable|disable}
Result: This enable/disable port ZDP function.
3. To enable/disable trunk ZDP function, use command set
zdp trunk <trunklist> {enable|disable} in group config
mode. This is shown in Table 394.
T 3 9 4 S Z
A B L E E T
Format
set zdp trunk
<trunklist>
{enable|disable}
Result: This enable/disable trunk ZDP function.
Important! By default, ZDP functions of all ports/trunks are
enabled. When ZDP function of a port/trunk is disabled,
contents of neighbor device information table of port/trunk
are cleared, and ZDP packets processing is suspended.
Note: A port/trunk can collect and send ZDP information
normally only when both ZDP function of port/trunk and
system ZDP function are enabled.
4. To set time interval for sending ZDP packets,
command set zdp holdtime <10-255> in group config
mode. This is shown in Table 395.
T 3 9 5 S Z
A B L E E T
Format
set zdp holdtime
<10-255>
Result: This sets the time interval for sending ZDP packets.
Note: ZDP holdtime value should be bigger than time value,
here give the advice that the holdtime value is three times of
time value.
5. To set time interval for sending ZDP packets,
command set zdp timer <5-255> in group config mode.
This is shown in Table 396.
P C
D P O R T O M M A N D
Mode
group config
T C
D P R U N K O M M A N D
Mode
group config
H C
D P O L D T I M E O M M A N D
Mode
group config
Function
This enable/disable
port ZDP function
Function
This enable/disable
trunk ZDP function
use
Function
This set time
interval for sending
ZDP packets
use