Table 311 Set Ntp Command; Table 312 Set Ntp Server Command; Table 313 Set Ntp Source Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
Purpose
Steps
188 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
This topic describes the configuration of NTP.
For the configuration of NTP, perform the following steps.
1. To enable/disable NTP, use command set ntp in global
configuration mode.
T 3 1 1 S N
A B L E E T
Format
set ntp
Result: This enable/disable NTP.
Note: Only after configuring this command,
commands can be configured.
NTP server, configuring IP address of NTP server is also
required.
2. To setup NTP server IP address, use command set ntp
server in global configuration mode.
312.
T 3 1 2 S N
A B L E E T
Format
set ntp server
Result: This setups NTP server IP address.
Note: At present only one NTP server can be configured.
several NTP servers are configured, the latter will cover the
former.
3. To configure source IP address which is used when switch
sends time synchronization request of NTP protocol,
command set ntp source in global configuration mode.
This is shown in Table 313.
T 3 1 3 S N
A B L E E T
Format
set ntp source
Result: This configures source IP address which is used
when switch send time synchronization request of NTP
protocol.
This is shown in Table 311.
C
T P O M M A N D
Mode
global config
S C
T P E R V E R O M M A N D
Mode
global config
S C
T P O U R C E O M M A N D
Mode
global config
Function
This enable/disable
NTP
the following
To synchronize time with
This is shown in Table
Function
This setups NTP
server IP address
Function
This configure
source IP address
which is used when
switch sends time
synchronization
request of NTP
protocol
If
use