Table 205 Set Qos Policer Parameters Command; Table 206 Set Qos Policer Parameters Command; Table 207 Set Qos Policer Parameters Command - Zte ZXR10 2920 User Manual

6. To configure the policer counter of the flux monitor, use
command set qos policer <0-255> counter <0-15>
{enable | disable }in global configuration mode.
shown in Table 203.
T 2 0 5 S Q
A B L E E T O S
Format
set qos policer
<0-255> counter
<0-15> {enable |
disable }
Result: This configures the policer counter of flux monitor.
7. To configure the overspeed disposal of the flux monitor,
use command set qos policer <0-255> exceed-action
{no-operation | drop}in global configuration mode.
is shown in Table 203.
T 2 0 6 S Q
A B L E E T O S
Format
set qos policer
<0-255> counter
<0-15> {enable |
disable }
Result: This configures the overspeed disposal of flux
monitor.
8. To configure the ingress session rate of the flux monitor,
use command set bandwidth feport <portlist> ingress
session <0-3> rate <64-100000>in global configuration
This is shown in Table 203.
mode.
T 2 0 7 S Q
A B L E E T O S
Format
set bandwidth
feport <portlist>
ingress session
<0-3> rate <64-
100000>
Result: This configures the ingress session rate of flux
monitor.
9. To configure the ingress session packet-type of the flux
monitor, use command set bandwidth feport <portlist>
ingress session <0-3> packet-type {unknowmulticast |
broadcast | unicast | multicast | MGMT | ARP | tcp-
control | tcp-data | udp | non-tcpudp} {enable |
disable}in global configuration mode.
Table 203.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 Service Configuration
P P C
O L I C E R A R A M E T E R S
Mode
global config
P P C
O L I C E R A R A M E T E R S
Mode
global config
P P C
O L I C E R A R A M E T E R S
Mode
global config
This is
O M M A N D
Function
This configures the
promise speed of
flux monitor
This
O M M A N D
Function
This configures the
overspeed disposol
of flux monitor
O M M A N D
Function
This configures the
ingress session rate
of flux monitor
This is shown in
135