Table 399 Set Ztp Command; Table 400 Set Ztp Port Command; Table 401 Set Ztp Trunk Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
246 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）
T 3 9 9 S Z
A B L E E T
Format
set ztp
{enable|disable}
Result: This enable/disable the system ZTP function.
Note: By default, system ZTP function is enabled.
system ZTP function is disabled, contents of switch topology
information table are cleared, and ZTP packets processing is
suspended.
2. To enable/disable port ZTP function, use command set
ztp port <portlist> {enable|disable} in group config mode.
This is shown in Table 400.
T 4 0 0 S Z
A B L E E T
Format
set ztp port
<portlist>
{enable|disable}
Result: This enable/disable port ZTP function.
3. To enable/disable trunk ZTP function, use command set
ztp trunk <trunklist> {enable|disable} in group config
mode. This is shown in Table 401.
T 4 0 1 S Z
A B L E E T
Format
set ztp trunk
<trunklist>
{enable|disable}
Result: This enable/disable trunk ZTP function.
Important! By default,
enabled. If ZTP function of a port/trunk is disabled, ZTP
packets processing of port/trunk is suspended.
Note: A port/trunk can collect and send ZTP information
normally only when both ZTP function of the port/trunk and
system ZTP function are enabled.
4. To configure ZTP parameters use the following commands
in group config mode as shown in Table 402.
C
T P O M M A N D
Mode
group config
P C
T P O R T O M M A N D
Mode
group config
T C
T P R U N K O M M A N D
Mode
group config
ZTP function of all ports/trunks is
Function
This enable/disable
the system ZTP
function
When
Function
This enable/disable
port ZTP function
Function
This enable/disable
trunk ZTP function