Configuring Through Telnet - Zte ZXR10 2920 User Manual

Configuring through Telnet

Purpose This topic describes the configuration of ZXR10 2920/2928/2952
through Telnet.
Telnet mode is usually used
Prerequisite
telnet.
local Ethernet interface logs in the telnet switch.
& password on the switch & make sure that local computer can
ping the IP address of the layer-3 port in the switch.
port address configuration refers to section 7. 13)
Create a new user using command create user <name>
admin|guest.
local <name> login-password [<string>].
Note: by default, the username & password is admin/zhongxing.
Steps
To configure through telnet, perform the following steps.
1.
2.
Configure the switch through the host connecting to the
Set login password using command set user
Run the telnet command on the host and input the IP
address of the switch management Ethernet port, as shown
in Figure 20.
F 2 0 R T
I G U R E U N E L N E T
Click OK to enter the interface as shown in Figure 21.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 Usage and Operation
when configuring the switch by
Set username
(Layer-3
37