Table 438 Set Loop Detect Port Vlan Command; Table 439 Set Loop Detect Trunk Command; Table 440 Set Loop Detect Trunk Vlan Command - Zte ZXR10 2920 User Manual

2. To enable/disable loop test function of specified port in
specified vlan,
<portlist> vlan <1-4094> {enable|disable} in global
config mode. This is shown in
T 4 3 8 S L
A B L E E T O O P
Format
set loopdetect
port <portlist>
vlan <1-4094>
{enable|disable}
Result: This enable/disable loop test function of specified
port in specified vlan.
Note: By default, port loop test function is disabled.
3. To enable/disable loop test function of a trunk,
command set
{enable|disable} in global config mode.
Table 439.
T 4 3 9 S L
A B L E E T O O P
Format
set loopdetect
trunk <trunklist>
{enable|disable}
Result: This enable/disable loop test function of a trunk.
Note: By default, loop test function of a trunk is disabled.
4. To enable/disable loop test function of a trunk on a
designated vlan,
<trunklist> vlan <1-4094> {enable|disable} in global
config mode. This is shown in
T 4 4 0 S L
A B L E E T O O P
Format
set loopdetect
trunk <trunklist>
vlan <1-4094>
{enable|disable}
Result: This enable/disable loop test function of a trunk on a
vlan.
Note: By default, loop test function of a trunk is disabled.
5. To enable/disable loop test protection function of specified
port, use command Table 441.
Confidential and Proprietary Information of ZTE CORPORATION
use command set
D P V C
E T E C T O R T L A N O M M A N D
Mode
global config
loopdetect
D T C
E T E C T R U N K O M M A N D
Mode
global config
use command set loopdetect trunk
D T V C
E T E C T R U N K L A N
Mode
global config
Chapter 10 Maintenance
loopdetect port
Function
This enable/disable
loop test function of
specified port in
specified vlan
use
trunk <trunklist>
This is shown in
Function
This enable/disable
loop test function of
a trunk
O M M A N D
Function
This enable/disable
loop test function of
a trunk on a vlan
295