Configuring L2 Acl; Configuring Hybrid Acl; Table 192 Config Acl Link Command; Table 193 Rule Command - Zte ZXR10 2920 User Manual

ZXR10 2920/2928/2952
Purpose
Steps
Steps
Purpose
Steps
128 Confidential and Proprietary Information of ZTE CORPORATION
(V1.0)
Access Switch User Manual （Volume I）

Configuring L2 ACL

This topic describes the configuration of L2 ACL.
For the configuration of L2 ACL, perform the following steps.
1. To enter in L2 ACL configuration, use command config
acl link number <acl-number> in global configuration
mode. This is shown in Table 192.
T 1 9 2 C
A B L E O N F I G
Format
config acl link
number <acl-
number>
Result: This enters into L2 ACL configuration mode.
2. To configure the rules of ACL, use command rule <rule-
id> {permit | deny} {ip | arp | other | any } [ether-
type <protocol-number>]
vlanid] {<source-mac wildcard> | any |<destination-mac
wildcard> | any} in ACL config mode.
Table 193
T 1 9 3 R
A B L E U L E
Format
rule <rule-id>
{permit | deny}
{ip | arp | other |
any } [ether-type
<protocol-
number>] [<dsap-
ssap>][cos]
[source-vlanid]
{<source-mac
wildcard> | any
|<destination-mac
wildcard> | any}
Result: This configures ACL rules.
E
ND OF STEPS
L2 ACL has been configured.

Configuring Hybrid ACL

This topic describes the configuration of Hybrid ACL.
For the configuration of Hybrid ACL, perform the following steps.
A C L L C
I N K O M M A N D
Mode
global config
[<dsap-ssap>][cos]
C
O M M A N D
Mode
ACL config
Function
This enters into L2
ACL configuration
mode
[source-
This is shown in
Function
This configures ACL
rules