Configuring Sqinq; Table 293 Set Sqinq Session Command; Table 294 Qos Remark In Sqinq Command - Zte ZXR10 2920 User Manual

Service It is necessary to operate Service Provider Network after
Provider Vlan Customer Port configuration.
Configuration successfully.
Tag Ports and all Customer Ports as Untag Ports.
All the packets exchanged in Service Provider Network carry two
layers of Tag which are Uplink Tag and Customer Tag.
packets leaving Service Provider Network,
layer of Tag left: Customer Tag.

Configuring SQinQ

Purpose This topic describes the configuration of SQinQ strategy policy.
Steps For the configuration of SQinQ, perform the following steps.
1.
2.
Configure all ports in Service Provider Network as
To configure SQinQ session,
session <1-256> customer-vlan <vlanlist> uplink-vlan
<1-4094> in global configuration mode.
Table 293.
T 2 9 3 S S Q Q S
A B L E E T I N
Format
set sqinq-session
<1-256>
customer-vlan
<vlanlist> uplink-
vlan <1-4094>
Result: This configures SQinQ session.
To set Qos remark,
remark in sqinq-session <1-256> profile <0-71> up
{no-change|enable-modify|disable-modify} dscp {no-
change|enable-modify
configuration mode.
T 2 9 4 Q R
A B L E O S E M A R K
Format
qos-remark in
sqinq-session <1-
256> profile <0-
71> up {no-
change|enable-
modify|disable-
modify} dscp
{no-
change|enable-
modify |disable-
modify}
Result: This sets Qos remark.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 8 Access Service
Packets can be exchanged
use command set sqinq-
C
E S S I O N O M M A N D
Mode
global config
use command set policy qos-
|disable-modify}
This is shown in Table 294.
I S Q Q C
N I N O M M A N D
Mode
global config
When
there is only one
This is shown in
Function
This configures
SQinQ session
in global
Function
This sets Qos
remark
181