Configuring Ztp; Table 396 Set Zdp Timer Command; Table 397 Show Zdp Command; Table 398 Show Zdp Neighbor Command - Zte ZXR10 2920 User Manual

6.
7.
E
ND OF STEPS
Result ZDP has been configured.

Configuring ZTP

Background Topology protocol (ZTP) is a protocol used to collect network
topology information.
collected through ZDP,
collection packets through the relevant port in the specified
VLAN to collect the topology information in the network (hop
count) within a specific range and to create a topology
information table which is used for knowing network topology
status and managing the cluster.
Purpose This topic describes the configuration of ZTP.
Steps For the configuration of ZTP, perform the following steps.
1.
T 3 9 6 S Z T
A B L E E T D P I M E R
Format
set zdp timer <5-
255>
To display ZDP configuration, use command show zdp
in group config mode.
T 3 9 7 S Z C
A B L E H O W D P
Format
show zdp
Result: This displays ZDP configuration.
To display neighbor device information table,
command show zdp neighbour [detail] in group config
mode. This is shown in Table 398.
T 3 9 8 S Z N
A B L E H O W D P
Format
show zdp
neighbour
[detail]
Result: This displays neighbor device information table.
To enable/disable the system ZTP function,
following command set ztp {enable|disable} in group
config mode. This is shown in Table 399.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 9 Network Management
C
O M M A N D
Mode
group config
This is shown in Table 397.
O M M A N D
Mode
group config
C
E I G H B O R O M M A N D
Mode
group config
With neighbor device information table
ZTP sends and forwards ZTP topology
Function
This set time
interval for sending
ZDP packets
Function
This displays ZDP
configuration
use
Function
This displays
neighbor device
information table
use the
245