System Clock Commands; Table 9: System Clock Commands - SMC Networks SMC2890W-AN Management Manual

13
sntp-server ip

System Clock Commands

These commands are used to configure SNTP and system clock settings on the
access point.

Table 9: System Clock Commands

Command
sntp-server ip
sntp-server enabled
sntp-server date-time
sntp-server daylight-saving
sntp-server timezone
show sntp
This command sets the IP address of the servers to which SNTP time requests are
issued. Use the this command with no arguments to clear all time servers from the
current list.
Syntax
sntp-server ip <1 | 2> <ip>
1 - First time server.
2 - Second time server.
ip - IP address of an time server (NTP or SNTP).
Default Setting
129.6.15.28
132.163.4.101
Command Mode
Global Configuration
Command Usage
When SNTP client mode is enabled using the sntp-server enabled command, the
sntp-server ip command specifies the time servers from which the access point
polls for time updates. The access point will poll the time servers in the order
specified until a response is received.
Function
Specifies one or more time servers
Accepts time from the specified time servers
Manually sets the system date and time
Sets the start and end dates for daylight savings
time
Sets the time zone for the access point's internal
clock
Shows current SNTP configuration settings
– 144 –
Mode Page
144
GC
GC 145
GC 145
GC 146
GC 147
Exec 147