SMC Networks SMC2890W-AN Management Manual page 225

bandwidth-control
downlink
bandwidth-control
downlink rate
Example
AP(if-wireless 0)# long-distance ctstimeout 56
For making changes effective, please execute make-RF-setting-effective
command after entering all three long distance parameters!
AP(if-wireless 0)#
This command enables the downlink bandwidth control for a VAP interface.
Syntax
bandwidth-control downlink <enable | disable>
enable - Enables the downlink bandwidth control setting.
disable - Disables the feature.
Default
Disabled
Command Mode
Interface Configuration (Wireless-VAP)
Command Usage
This command enables the rate limiting of traffic from the wired network as it is
passed to the VAP interface. You can set a maximum rate in Kbytes per second.
Example
AP(if-wireless 0: VAP[0])# bandwidth-control downlink enable
This setting has not been effective !
If want to take effect, please execute make-security-effective command !
AP(if-wireless 0: VAP[0])#
This command sets the downlink bandwidth rate for a VAP interface.
Syntax
bandwidth-control downlink rate <rate>
rate - The allowed downlink rate in Kbytes per second.
(Range: 100-12000 Kbytes per second)
Default
100 Kbytes per second
Command Mode
Interface Configuration (Wireless-VAP)
Chapter 24
– 225 –
| Wireless Interface Commands