SMC Networks SMC2890W-AN Management Manual page 191

Command Usage
◆
◆
Example
port-priority (STP
This command sets the spanning tree path cost for the VAP interface.
Interface)
Syntax
Command Mode
Global Configuration (STP interface)
Command Usage
◆
◆
Example
bridge mac-aging
This command sets the MAC address table aging time.
Syntax
Default
300 seconds
This command is used by the Spanning Tree Protocol to determine the best
path between devices. Therefore, lower values should be assigned to interfaces
with faster media, and higher values assigned to interfaces with slower media.
Path cost takes precedence over port priority.
AP(stp-if-wireless 0: VAP[0])# path-cost 512
AP(stp-if-wireless 0: VAP[0])#
port-priority <priority>
priority - The priority for the VAP interface. (Range: 0-63)
This command defines the priority for the use of an interface in the Spanning
Tree Protocol. If the path cost for all interfaces on a bridge are the same, the
interface with the highest priority (that is, lowest value) will be configured as an
active link in the spanning tree.
Where more than one interface is assigned the highest priority, the interface
with lowest numeric identifier will be enabled.
AP(stp-if-wireless 0: VAP[0])# port-priority 10
AP(stp-if-wireless 0: VAP[0])#
bridge mac-aging <aging-time>
aging-time - The time after which a learned MAC address is discarded.
(Range: 10-1000000 seconds)
– 191 –
Chapter 21
| Spanning Tree Commands